A ready blended coating that once cured, provides a waterproof Methane and Carbon Dioxide barrier. Triton TT Vapour Barrier can be retro-applied as a waterproof and gas-proof membrane to concrete, masonry and brick substrates or as an alternative to sheet membranes in new construction. It can be applied by airless spray, roller or brush to walls, floors and soffits.
Triton TT55 ME is a two component polymer modified cement based, flexible, protective and waterproof membrane coating. It is suitable for either vertical or horizontal surfaces and ideal for areas which are liable to cracking or deformation on the surface, and can be successfully used at wall/floor junctions. The polymer emulsion additive imparts high adhesion and flexibility along with its own high level of water resistance. It is suitable for the internal and external waterproofing of concrete, sound brickwork and cement based elements of water retaining and water resisting structures such as basements, retaining walls, lift pits, swimming pools, construction joints, underpinning joints, balcony decks, bund linings or terraces etc.
A single component, polymer modified cement “tanking” system for walls and floors, designed to be applied as a waterproof slurry. TT 55 is a highly effective damp proof membrane for brickwork, concrete or any cementitious substrate. Surfaces to be treated with TT55 should be correctly prepared, free from all loose materials and contaminants and be in a sound and solid condition. For application to floors, TT55 should be applied directly to the structural slab. For wall applications, TT55 should be sandwiched between sand/cement render coats. For all TT55 applications, special attention should be given to wall/floor junctions.
Triton TM8 / Platon P8 is used as a waterproofing drainage layer applied to the inside face of basement and below ground walls and floors within a drained cavity membrane system. TM8 / P8 is manufactured from High Density Polyethylene and is impermeable to water, water vapour or Radon gas.
TM 20 / P20 is a high capacity drainage membrane recommended for use on all floor applications below ground due to its ability to control free flowing water. The deep stud profile is designed to resist blockages caused by lime deposits.
Triton TM20 / Platon P20 is most often incorporated within the basement floor build-up and can be used above or below suitable closed cell insulation (contact the Technical Department for guidance), to accommodate the requirements for Aquachannel drainage. TM20 / P20 is used in conjunction with Triton Sealing Rope, Overtape and Cornerstrip.
A 3mm polypropylene cavity drain membrane suitable for direct plastering. Suitable for use as an isolating plaster membrane following remedial treatments.
Triseal is a solvent free, two part epoxy resin coating, typically used as a surface damp proof membrane and a water vapour suppressant. Ideal for use beneath raised access floors, in plant rooms and bunded areas. It is also suitable for application on damp surfaces, such as sand/cement and cement floors subject to rising damp or containing residual construction moisture. Triseal can be used as a general purpose coating for surfaces subject to foot and light wheeled traffic. Triseal can be applied using a brush or medium pile roller onto sound, clean surfaces.
Can't find what you're looking for? We can help.