A masonry water repellent concentrate that dilutes with water to form a stable solution for use on mineral substrates. Triton Triproof AQ is a highly effective water repellent solution based on a blend of Silane and polysiloxane resins. Suitable for use over masonry, brickwork, concrete and renders. Superior performance is obtained on alkaline surfaces such as new renders and concrete. Supplied as a concentrate for dilution with water.
A ready blended coating that once cured, provides a waterproof Methane and Carbon Dioxide barrier. Triton TT Vapour Barrier can be retro-applied as a waterproof and gas-proof membrane to concrete, masonry and brick substrates or as an alternative to sheet membranes in new construction. It can be applied by airless spray, roller or brush to walls, floors and soffits.
A single component, polymer modified cement “tanking” system for walls and floors, designed to be applied as a waterproof slurry. TT 55 is a highly effective damp proof membrane for brickwork, concrete or any cementitious substrate. Surfaces to be treated with TT55 should be correctly prepared, free from all loose materials and contaminants and be in a sound and solid condition. For application to floors, TT55 should be applied directly to the structural slab. For wall applications, TT55 should be sandwiched between sand/cement render coats. For all TT55 applications, special attention should be given to wall/floor junctions.
Triton TM8 / Platon P8 is used as a waterproofing drainage layer applied to the inside face of basement and below ground walls and floors within a drained cavity membrane system. TM8 / P8 is manufactured from High Density Polyethylene and is impermeable to water, water vapour or Radon gas.
A water and salt resistant additive for cement mortars. Improves workability of the mix. Particularly recommended for use in mortars used for internal cement rendering (replastering) of walls affected by rising dampness. Supplied in concentrate form and diluted for use. Supplied in 5 litre and 25 litre containers.
A 3mm polypropylene cavity drain membrane suitable for direct plastering. Suitable for use as an isolating plaster membrane following remedial treatments.
A waterproofing and plasticizing additive for sand and cement renders and mortars. Improves the workability of the mix and reduces the amount of water required to provide a workable mix therefore producing a more dense render. Recommended for use in replastering of walls affected by rising dampness. Supplied in concentrate form in 25 litre containers.
Ancillaries for damp proofing includes polymer emulsion based primers and additives for cement renders and mortars, a pre-packed Fillet Seal mortar, salt neutraliser and fixings and tape seals for PB2 Mesh.
Can't find what you're looking for? We can help.